L3600FD DSP power amplifier, live
L3600FD DSP power amplifier, live
A 2-channel live DSP power amplifier rated 2 x 1800 W, with integrated FIR Drive speaker processing and SONICUE control.
Reach the top of the L-Series with the processing built in. The L3600FD delivers 2 x 1800 W from an efficient Class-H output stage, with FIR-Drive linear-phase tuning and XLR/NL4 connectors. Per-channel EQ, delay, and limiters shape the system, and a deep protection set — thermal, DC, HF, Back-EMF, and short-circuit — keeps it running hard. A >109 dB signal-to-noise ratio and 32 dB gain keep the floor quiet. Touring, arena, large worship, performing-arts center.
Key features
Maximum L-Series output
2 x 1800 W with the range's lowest noise floor (>109 dB signal-to-noise).
Efficient by design
a Class-H output stage delivers high power with less heat and draw.
Loudspeaker tuning on board
FIR-Drive linear-phase processing with per-channel EQ, delay, and limiters.
Built to keep running
protection against thermal, DC, HF, Back-EMF, and short-circuit faults.
Wire it fast
balanced XLR inputs and NL4 outputs for quick, reliable hookup.
Matched to local mains
ships factory configured for 240 V, 230 V, 120 V or 100 V mains, 50 to 60 Hz.
Two-channel power amplifiers
L Series and C Series Amplifiers
Complete the System
Where this unit fits, and what it pairs with.
productPage.features
Take the speaker processing with you. The L3600FD pairs 2 x 1800 W of Class H power with fully integrated FIR Drive, so FIR filters, PEQ, and per-channel delay live in the amplifier instead of a separate box. Set it up and supervise it in SONICUE, drive down to 2 ohm, or bridge for 6000 W into 4 ohm, cooled by 3-stage front-to-rear fans and guarded by a full protection suite. Two rack units. Touring rigs, live production, theaters, and performance spaces that want processing and power in one chassis.
- Power with headroom: 1800 W per channel into 4 ohm, 3000 W into 2 ohm, 6000 W bridged into 4 ohm.
- Processing on board: FIR Drive puts FIR filters, PEQ, and per-channel delay inside the amplifier.
- Set up in SONICUE: full configuration and supervision from Dynacord's sound system software.
- Class H output stage: matched to the power class for efficient, reliable touring duty.
- Protected and cooled: audio limiters plus temperature, DC, HF, back-EMF and short-circuit protection, 3-stage fans.
productPage.info.specs
Overview & Features
- Configuration
2-channel, Class H
Acoustic Performance
- Frequency Response
10 Hz to 21 kHz (±1 dB)
- THD+N
< 0.05 %
- Crosstalk between channels (dBA)
< -80 dB
- Signal-to-Noise Ratio
> 109 dB
Power & Amplification
- Total Output Power*
3600 W